This site is being deprecated.

Please see the official X‑Plane Support page for help.

0 votes
asked by (14 points)

Hi

I got the cycle dump ,message.

Since, the window seen by following the link under is presented permanently, and I cannot find out how to close it.

Help is appreciated:)

Thank you.

 

http://vela-x.com/x_plane/cycledumpscreen.JPG

 

Harald Eide

Norway

 

1 Answer

0 votes
answered by (19.3k points)
Please go to Settings > Data input & output and uncheck any boxes you don't want or didn't check. Especially check the "detail" boxes at the bottom of the window. X-Plane interprets some settings wrong in 10.50 that can cause extra boxes like this to come up after an update.
commented by (14 points)
Hi

Thank's for your fast answer. Actually I went to Settings > Data input & output, and as far as I remember did uncheck at least a few of the boxes. But maybe I was too tired and did not pay enough attention to it the first time,- anyway your advice helped and the window closed. Thanks a lot !

Regards

Harald Eide

Norway
...