This site is being deprecated.

Please see the official X‑Plane Support page for help.

0 votes
asked by (136 points)
I went through all the steps of the Cold&Dark Procedures.txt but when I get to pulling out the engine start switches the light does not illuminate.If I then let go I can here a rev up but then it dies out. On HYD light above hydraulic switch number 4 there is a sys fault light displayed. Is this a bug or systems not fully implemented yet. I can have the plane going if I start it engines running but not start from cold and dark. This is X-Plane 11.00pb11 on Linux OS.

Please log in or register to answer this question.

...