CH Fighterstick and throttle cannot calibrate

Question

I have been working with Jon Soucy at CH and having significant difficulties on using the calibration.  A sometimes the calibration works, but most of the time the calibration does not work.  When I try to calibrate, I only get a very small RED indicator where normally the calibration should cover about 1/2 of the area in each area with the Roll, Pitch, and Throttle.  Most of the time, the red are is moved to the left side,vs if it works, I gets the correct 50% to calibrate.  Once in a while it will work, and when it does, it is wonderful.  Mostly it does not allow calibration.

This is a CH Fighterstick and Trottle on an X-Plane 11

Comments

I deleted everything from X-Plane 11 and 10 to be certain that there would be no "corruption" or conflicts.  I am now running only 11 using the new current updates.

As a comment, while Jon has been very helpful he has noted that this an X-Plane issue, not a CH issue.

Answer 1

Hi Rick,

I am not with Laminar Research; just a flight simmer from down under.

If you were using saitek products, now logitech, my message to you would be to delete and ditch their software and connect and configure the instruments only through x-plane.  The only way their products work.

Try doing the same with the CH products you have.  Use no other ancillary software. You may solve your problem in using this methodology.

Good luck.

Glenn

Answer 2

For some reason, and I have no idea, the CH allowed my to change the stick on the red levels, thus I could fly.  Earlier I could not roll, pitch or throttle, and now it happen as if my magic.

Any clue that makes it work or not work?