plane comes to the right

Question

Hello,
in the attached image it is clear that a flying surface has moved away from the normal layout without having ordered the movement and that surface was been in good position at takeoff, this problem only points out when I select the "Columbia 400" aircraft and it happens that after taking off the plane tends to go right, consider that the only commands after takeoff are unlocking the brake full throttle adjusting the trimmer in elevation using the buttons "pitch trim up" and "pitch trim down", consider that everything works well when flying with other airplanes and i try reset the errors by resetting all the systems in the "columbia 400" settings.
I cordially greet you and I am waiting for your answer

Comments

This looks like a elevator trim tab to me.   And it looks to be on the up side of the elevator which would force the elevator DOWN.   This would  normally make the plane nose over.

To check what is going on with the elevator trim tab....When on the ground, go to CHASE plane view, pan to back of plane as your picture shows and run the elevator trim Up& Down to see what is going on with the trim tab...   Don't know why it would turn to the Right....

Maybe you have individual profile for this plane??????That affects this plane and not the others.....   Just my 2 cents...hehe  Good Luck.  Hope you find the problem..

---

yes, if I use a trim command only the right surface of elevator tail move, but it's very strange because i set the buttons of keyboard and the buttons of joitick for make a neutral elevator trim and all work perfevtly with other plane.
Please can you tell me where i can find if there is an "individual profile for this plane"?