This site is being deprecated.

Please see the official X‑Plane Support page for help.

0 votes
asked by (12 points)

Hi All,

I just tried to load into XP11 today and I got absolutely no scenery loaded. No auto-gen, paid scenery object, default scenery at all. Yesterday this worked fine, the only thing I have done is update the navigraph data cause it said it was out of date. 

I have tried the following so far:

  • Delete the scenery file and let x-plane regen it
  • Remove all custom scenery
  • Remove XP completely and reinstall
All of this has not helped to resolve the issue. below are two screenshots of what it looks like for me. both of these are taken on the ground at an airport I flew out of yesterday, so I know the paid for scenery here was working.
I have tried about 10 airports and all have the same issue so I know it is not the custom scenery. I have also attached the generated LOG file. 

1 Answer

0 votes
answered by (19.3k points)
What does the log from the complete new install look like? The attached log shows a lot of plugins installed, which could be causing this. Do you see this with a new, clean install with absolutely no addons installed?
commented by (10 points)
i have the same problem.
commented by (10 points)

I got a response from Laminar Tech -- Jennifer Roberts to be specific. She had me download Dataref Editor and change the art control  "reno/draw_fft_water" from 1 to 0. It worked. I flew 110 NM and had all scenery and runways load correctly.

To change the setting, you have to click the value... in this case, click directly on the "1". It took me a few minutes to figure that out.

...