After the update this morning the flaps started falling off the default 172 at the drop of a hat even tho I am WELL within operating standards. I have seen a whole lot of rediculous answers in the posts that have come out over the last 5 years of so on the matter while trying to figure it out.
"You can't set the first notch until you are below 110 Knots..."
Actually the 110 knots is for FULLY EXTENDED flaps not first notch.
"You have to set it in plane maker under Standard>Viewpoint..."
According to the plane maker software itself That is only for painting the arcs on the airspeed indicator.
Sceriously, someone must know, the speeds are literally printed on the label for the flaps. 140, 120, and 110, but the plane does not seem to know it anymore.
So where do I adjust the data for the model? I've been all over Planemaker and either keep overlooking it or it's somewhere else.
Can anyone help me out here?