This site is being deprecated.

Please see the official X‑Plane Support page for help.

0 votes
asked by (12 points)

0Hey Simmers,

I recently got a 3 monitor setup. I did setup my 3 monitors for xplane by tweaking the FOV for each monitor. As soon as I load Jardesign a320 the camera angle on the left monitor and the middle monitor resets to same foward cockpit view. For any other aircraft (addon/stock) the camera angle does not reset only for this specific aircraft. Could use some help here.


1 Answer

0 votes
answered by (5.3k points)

Hi pranav_d,

I am not from Laminar Research; just a flight simmer from down under.

You haven't  what version of X-Plane you are using.  If it is not the official, genuine, oriiginal and true version of X-Plane developed by Laminar Research then you are in the wrong forum.  This is not an alternative 3rd party hybrid modified version of x-plane forum.

You need to have a look at the Q&A problems listed under this link found at  You need to scroll and read through them and in particular have a look at the following link in this group where an answer has been provided by a Laminar staff member who was the moderator of this forum some time back.  The link is

You should also consider/view  the Q&As related to this link found at  and in particular