This site is being deprecated.

Please see the official X‑Plane Support page for help.

0 votes
asked by (12 points)
i keep getting the statement make sure you are using full power when I am trying to take off in the training mode or in any mode. I am using a saitek throttle control and it is set up correctly however the software does not recognize that i am using full power when i am ? any solutions

1 Answer

0 votes
answered by (5.3k points)

Hi Frank,

I am not with Laminar Research; just a flight simmer.

What software have you used to setup the Saitek products?  You need to "dump" by complete deletion, the Saitek software and install the components through X-Plane.  Do the installation before you start a flight.

Have a look at the following link from Michael Brown which can be found at https://www.youtube.com/watch?v=hU_TuALAlJk      Michael specialises in purpose built PCs predominantly for X-Plane.  His company is recommended by Laminar Research as the PC supplier in the USA.

Hope this helps

Glenn

...